Harbor:Equipment
ED equipment issues[1]
For equipment issues, notify the Area Charge RN to report the issue. Also notify the appropriate director below so they can follow up:
- Cisco phones - notify Charge RN to get replacement phone and Dr. Chappell
- Ultrasound equipment - notify Dr. T. Jang
- AED and RME equipment - notify Dr. Chappell
- PED equipment - notify Dr. P. Padlipsky
- IT equipment, including computers and landline phones - place a ticket by using hospital intranet IT support icon or calling in ticket, and also notifying the appropriate area Director above to follow up.
iCare[2]
This is the new version of our current model. Quick tips for getting started:
- To turn on, hold the square button on the side about 2 seconds (it will beep when it turns on)
- Insert probe (same as old ones, spares are in the supply room I the special equipment cart); it has a red lens cap to help keep it clean – please replace this after use
- The light turns green on the tip when it is level; there will be a warning on the screen if you are too far or too close to the eye
- Push the arrow to measure … it will average the measurements (discards highest and lowest of 6) and display in green; if there is too much variability, it recommends repeating your measurement.
- Hold the square button down for 2 seconds again to turn it off.
If you get an error message, please email Brad Chappell.
Teaching Slit Lamp
- Diagram of How to Use It