Harbor:Equipment

ED equipment issues[1]

For equipment issues, notify the Area Charge RN to report the issue. Also notify the appropriate director below so they can follow up:

  • Spectralink phones - notify Charge RN to get replacement phone and Dr. A. Wu
  • Ultrasound equipment - notify Dr. T. Jang
  • AED equipment - notify Dr. A. Wu
  • RME equipment - notify Dr. B. Chappell
  • PED equipment - notify Dr. P. Padlipsky
  • IT equipment, including computers and landline phones - place a ticket by using hospital intranet IT support icon or calling in ticket, and also notifying the appropriate area Director above to follow up.

iCare[2]

This is the new version of our current model. Quick tips for getting started:

  1. To turn on, hold the square button on the side about 2 seconds (it will beep when it turns on)
  2. Insert probe (same as old ones, spares are in the supply room I the special equipment cart); it has a red lens cap to help keep it clean – please replace this after use
  3. The light turns green on the tip when it is level; there will be a warning on the screen if you are too far or too close to the eye
  4. Push the arrow to measure … it will average the measurements (discards highest and lowest of 6) and display in green; if there is too much variability, it recommends repeating your measurement.
  5. Hold the square button down for 2 seconds again to turn it off.

If you get an error message, please email Brad Chappell.

Teaching Slit Lamp

  • Diagram of How to Use It

See Also

References

  1. A.Wu Dir AAED 2/14/17
  2. Chappell DIR RME 5-29-18